Have questions? SBM sales representatives are available for live chat now WELCOME TO SBM MACHINERY!

Talcum Powder Manufacturing Process

Talcum Powder Manufacturing Process

Talcum Powder Manufacturing Process Machine shortcomings

With the extensive development of non-metallic minerals in the field of ultra-fine powder applications, downstream companies are increasingly demanding non-metallic mineral products. In particular, there is a higher requirement for product fineness. This makes the traditional Talcum Powder Manufacturing Process Machine seem to be incapable. These problems with traditional Talcum Powder Manufacturing Process Machines have plagued mineral processing companies and equipment manufacturers. These problems are mainly manifested in:

  • First, the product fineness is low, the fineness of the ordinary Talcum Powder Manufacturing Process Machine is generally below 600 mesh, these devices can only occupy the lower end powder application market.
  • Second, the mechanical failure rate is high, the power consumption is large, the noise is large, and the emission pollution is large.
  • Third, the system efficiency is low, the product separation system separation effect is not ideal, a large number of fine powder can not be effectively collected and repeated circulation in the system to cause power waste.
  • Fourth, the main bellows air duct design has made mistakes. The larger particles entering the material of the grinding area and the particles that have been mined in the future are often thrown into the bellows and gathered at the tail of the volute, and continue to extend forward, so that the amount of over-wind is gradually reduced. Causes traffic jams, no powder or less powder, affecting production.

Talcum Powder Manufacturing Process Machine installation

  • First, the transmission base is hoisted into the pit to fill in, pay attention to control a certain height, and then use the level to correct the upper plane “A”, and install the transmission on the “A” surface with bolts.
  • Second, Talcum Powder Manufacturing Process Machine host installation. Before installation, the rubber shockproof pad should be placed on the bottom of the base plane and the cement foundation contact and the anchor bolt connection. Then, use the frame level to correct the “B” plane of the base. The correction point is four points of the crosshair, and the adjustment is made at the same time. The coupling halves of the two couplings “C” and “D” should be less than 0.20 mm, and the E1-E2 non-parallelism should not be greater than 0.1 mm. The gap between “E1” and “E2” should be kept at 5-8. Within millimeters.
  • Third. The position and height of the pipeline installation shall be installed according to the general plan, and shall not be arbitrarily altered or raised. The joints of the pipelines shall be sealed and there shall be no air leakage after tightening. Electrical equipment should be accurate and reliable, and should be tested after the components are installed.

Get Price And Support

Simply complete the form below, click submit, you will get the price list and a SBM representative will contact you within one business day. Please also feel free to contact us by email or phone. ( * Denotes a required field).