Have questions? SBM sales representatives are available for live chat now WELCOME TO SBM MACHINERY!

Mica Powder Making Machine

Mica Powder Making Machine

Mica Powder Making Machine common troubleshooting

  • 1, no powder or no powder, low yield. Causes: 1, the locker is not adjusted well, the seal is not strict, causing the powder to suck. 2, the blade wears a lot, the material can not afford to shovel. Remedy: 1. Check and adjust the seal of the locker and find that the air leak should be scraped. 2. Replace the new blade.
  • 2. The finished powder is too thick or too fine. Causes: 1. The blade of the analyzer is seriously worn and cannot be graded. 2. The fan air volume is not appropriate. Remedy: 1. Replace the length of the blade and turn off the air volume of the small fan to solve the rough. 2, too fine should increase the volume of imported air.
  • 3. The host current rises and the fan current drops. Causes: 1. The feed is excessive, the air duct is blocked by the powder, the pipeline exhaust is not smooth, the circulating airflow generates heat, the main current increases, the machine temperature rises, and the fan current decreases. Remedy: 1, reduce the amount of feed, remove the wind tunnel powder. 2. Open the large air duct valve, and the temperature of the incoming material is controlled below 6 °C.
  • 4. The main engine is noisy and has a large vibration. Causes: 1. The feed amount is small. The blade is severely worn, the material cannot be shoveled, and the anchor bolts are loose. 2, the material hard impact is large, or the material layer 3, the grinding roller grinding ring is seriously deformed. Remedy: 1. Adjust the feeding amount and replace the new blade. 2. Replace the feed size. 3. Replace the grinding roller and grinding ring.
  • 5. Fan vibration. Causes: 1. Powder or wear imbalance on the blades. 2. The anchor bolts are loose. Remedy: 1. Remove the leaf powder or replace the blade. 2. Tighten the anchor bolts.
  • 6. The transmission and the analysis tank are heated. Causes: 1. The viscosity of the oil is large and the oil is thick. The thread pump oil cannot be used to make the upper bearing lack of oil. Remedy: 1. Check if the oil grade and viscosity match the requirements. 2. Check the running direction of the analyzer.
  • 7. The grinding roller device enters the powder bearing damage cup. Causes: 1, oil cut, or seal damage. 2. Long-term lack of maintenance and cleaning. Remedy: 1. Refuel in time according to the specified time. 2. Regularly clean and replace the oil seal.

Get Price And Support

Simply complete the form below, click submit, you will get the price list and a SBM representative will contact you within one business day. Please also feel free to contact us by email or phone. ( * Denotes a required field).